通用banner
Your current location : Home >> News >> Industry news

Contact usContact Us

Jiangsu Jinluo New Material Technology Co., Ltd

TEL:13801432164

TEL:0523-86975988

Mail box:13801432164@163.com

website:en.jlhose.com

Address: North side plant in the incubation park of Smart Power Town, Yaojia Road, Jiulong Town, Hailing District, Taizhou

Characteristics and benefits of TPU microporous aeration hose

2021-03-03 03:48:48
a

TPU microporous aeration hose is a soft tubular aerator made of TPU material imported from Germany through high temperature melting extrusion die. There are pores on the circumference of TPU microporous aeration hose for aeration. The pores are long and thin, and the width is variable within a certain range, which can produce medium and micro bubbles in water. The bubble rising speed of aeration hose is slow, and the air distribution is uniform and the oxygen utilization rate is high.

The wall thickness of microporous aeration hose is only 0.4mm, and the airway is short and straight, so the air pressure loss is small. The effect of hydrostatic pressure is flattened when aeration is not, so it can avoid backfilling of mud water to a certain extent. The inner and outer surface of the microporous aeration hose is very lubricating, and it is not easy to hold the biofilm, and it does not need air filtration equipment, so aeration can be stopped at any time. And when the aeration is stopped, it will not block.

The micro porous aeration hose is easy to assemble, and the gas transmission pipe and aeration pipe at the bottom of the tank are integrated, and no additional pipeline equipment is needed, and the cost is lower than that of other micro aerators. Compared with other microporous aerators, the aeration hose has the following advantages:


TPU软管

1. The aeration hose has the function of gas transmission, which saves the cost of gas transmission pipeline.

2. It can be bent and packed, small in volume and low in transportation cost.

3. The device is simple, the cost of the device is low, and there is no risk of air leakage.

4. The aeration hose expands when aeration, flattens when it is not aerated, and the variable micropores are closed. Therefore, the time of stopping aeration will not be blocked no matter how long or short.

5. Acid and alkali corrosion resistance, no aging, no tearing, long service life.

6. The wall thickness of the hose is only 0.4mm, the airway loss is small, the surface finish of the inner and outer surfaces of the hose is high, and the biofilm is not attached.

7. The oxygen utilization rate is high, the price is lower than other aerators, and the performance price ratio is high.

8. There is no special requirement for air source, and no air filter is needed.

9. The air hole density of the hose is large, the air distribution is uniform, the service area is large, and there is no dead angle.

The aeration hose overcomes the disadvantage of poor stability of other aerators and has no worries.

If you need aeration products, you can contact our company!


 


Home          Products           news            case            Contact         Inquiry      

   factory building in the north of Incubation Park, Yaojia Road, Jiulong Town, hailing, Taizhou
  138-0143-2164
   0523-86975988

Large diameter flat hose,TPU hose